|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Re: I will suggest once again posted by fatbottle on January 24, 2007 at 23:42:43:
Hi.This is a AUDIO DIYers' forum, for we Joe Blows to get the best out of our relatively limited available sources. To keep the parts from overheating is one of time & cost saving priorities.
We were not discussing an OEM manufacturers' productivity flow chart whereby meeting deadline of shipment is the first priority. Any damage done to the parts of the PCBs due to whatever reasons, e.g. overheating in the solder bath, is already taken care of as part of the overall production costs.
The difference is someone pay for your mistakes. If you run the OEM, would you take such manufacture pitful or dropout like nobody's business?
Again, this is another apple to orange comparison from you. Thanks but no thanks.
c-J
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Now you understand.- wrong perspective ! - cheap-Jack 07:41:38 01/25/07 (4)
- Re: Now you understand.- wrong perspective ! - fatbottle 10:34:54 01/25/07 (3)
- I'm with c-J on this one. - Ray Moth 14:57:00 01/25/07 (2)
- YES, your experience really proves who's "lack of pratice". . - cheap-Jack 07:57:21 01/26/07 (0)
- Lack of practice is not a valid reason to shove wet cotton buds on your work ;) - fatbottle 15:28:52 01/25/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
