|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Practice PCB soldering posted by rneedle on January 23, 2007 at 04:52:57:
Folks,Thanks for the responses. I will check out the Velleman or perhaps just order another Pluto board.
I have no need for cleaning the board before starting. I just meant that I didn't wish to get a used PCB, desolder, and practice by resoldering; I couldn't be sure that the board was pristine after desoldering.
I have a Weller WLC100 but have to questions: 1) What numerical setting for the heat is equivalent to a 25-30W iron? and 2) What size tip should I order for a typical PCB soldering job?
Thanks again....
Richard
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Thanks and two more questions - rneedle 09:05:47 01/23/07 (1)
- Re: Thanks and two more questions - Henry Pasternack 09:28:41 01/23/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
