|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: I have just started going down this path posted by Russ57 on January 24, 2007 at 12:13:16:
I am finishing up fine tuning speakers for my biamp system.
Audax Aerogel 5 1/4 and 4" in parallel without inductor.
Dynaudio D260 with just a 5uFd GE oiler and .1 Vit Q.
Just added a 50 ohm resistor across the Dynaudio D260.
BTW the Audax drivers are in dipole.
Sounds great - dynamic, alive and clarity I've never heard.
Driving it with a SE mosfet amp till I finish my SE KT66 amp.
Rhythmic mosfet plate amp on my woofer/subwoofer below 150 Hz.
With my Monica 2 12B4 preamp with Dave Slagle's AVC WOW !!!
Using Radio Shack solid core 18ga hook-up wire for speakers.So I concur the less crossover parts used the better the music.
That is if you have speakers capable of being without them.
The Audax Aerogels have a nice smooth high end roll-off.
Now to build a better way of mounting the drivers because
they are about 8" apart now (measured center-to-center) also
to make it prettier too - maybe some cherry stained birch.DanL
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Me too... - danlaudionut 13:27:32 01/24/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
