|
Speaker Asylum General speaker questions for audio and home theater. |
|
|
|
Speaker Asylum General speaker questions for audio and home theater. |
|
In Reply to: Implementing Full Range drivers posted by hailtothevictorz on November 27, 2024 at 09:04:06:
I have favored full range designs for decades. In my case, however, I choose large electrostats that are truly capable of covering the extremes. What I value most is coherency - where there are no audible seams and directivity is consistent from top to bottom.
Using dynamic drivers, I would prefer using a small driver to cover the majority of the range supplemented by a woofer only for the bottom octaves where wavelengths are longer and transitions are less audible.
Putting a wide dispersion tweeter atop a large full range driver that has already significantly clamped down dispersion at its upper range creates a most obvious discontinuity to these ears.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- And yet a third opinion - E-Stat 07:29:50 11/29/24 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
