Run out of ideas on my 'poinz' 6V6

Tube DIY Asylum

Do It Yourself (DIY) paradise for tube and SET project builders.

I built a 'poinz' 6V6 with PPP 7C5s. I have tested various components & have constantly improved the amp. Last improvement was a plate choke on the 6CG7 phase splitter.
The only idea I have left is a superior phase splitter tube, although the Raytheon 6CG7 is good. I do have two octal socket positions left on the chassis with removing the octal hole size 9-pin socket.
What would you recommend for a phase splitter tube(s). I can apply up to 320 volts plate & up to 50 ma for the phase splitter. Right now, I use a negative supply of 140 VDC on the 6CG7 cathode.
Other tubes I tried were various 6CG7s, 6922s, 12AV7 (yuk), Tele ECC85, Sylvania 6SN7GT and 2C22 that has a slight edge on the Ray 6CG7.

This post is made possible by the generous support of people like you and our sponsors:

McShane Design

Topic - Run out of ideas on my 'poinz' 6V6 - JIMMY 12:36:32 03/19/06 (7)

Say, what about that 7AF7 Tung Sol with round plates?....nt - JIMMY 18:04:02 03/19/06 (0)

A couple of ideas - andy evans 16:05:03 03/19/06 (1)

Re: A couple of ideas - GEO 17:06:06 03/19/06 (0)

Great minds. - Poindexter 14:31:35 03/19/06 (2)

6005 - JIMMY 17:52:24 03/19/06 (1)

Re: 6005 - Poindexter 18:39:51 03/19/06 (0)

Add: - JIMMY 13:00:34 03/19/06 (0)

You can not post to an archived thread.