|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: preamp desing using Hammond 124B posted by PeterS on December 18, 2005 at 07:25:43:
I've used them extensively, they work very well as long as you keep any DC out of them (parafeed or balanced differential etc) and you don't have too big a signal level. Preamp levels are fine, I would NOT use one to drive a 300B for instance.The other problem with them is they are not shielded and run at high impedance levels, they pick up everything, proper placement is crucial to get good results out of them.
John S.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: preamp desing using Hammond 124B - John Swenson 18:45:09 12/18/05 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
