|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: What size bleeder resistor to drain filter caps? posted by RioTubes on January 27, 2007 at 10:24:02:
> I plan to solder some clips on the resistor leads to make it handy.A bleeder resistor resides in the circuit permanently and prevents the need to do what you're suggesting. Bleeders also improve regulation. If only for reasons of safety, that's how all tube amplifiers should be built.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Technically, that's not a bleeder... - Triode_Kingdom 11:11:09 01/27/07 (2)
- It's good to have a high-value resistor permanently connected - Ray Moth 17:08:15 01/27/07 (1)
- voltage limitations for resistors - RayP 06:24:03 01/28/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
