OTL Asylum OTL, Output Transformerless Amplifier User Group.

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ OTL Asylum ]

---

[ Alert Moderator ]

---

In the US - ...No , im in New Zealand . 230 - 240 VAC

Posted by Satelliteman (A) on September 20, 2006 at 19:22:18

In Reply to: Re: collective current posted by Ralph on September 20, 2006 at 15:13:32:

Hi Ralph , I sent you a pic of both my of amps together on the dining room table .
These are the voltages / references that I have measured in the amps are as follows

Output stage supply is 135 VDC
Driver Supply is +325 & -327 .
Bias value reference is approx -50
Pins 2 & 4 ( V4 ) is +292
Pins 1 & 4 ( v2 ) is 46.9 , and Pins 3 & 6 ( v2 ) is 53.2
Pins 3 & 6 ( V1 + 1.6
Pins 6 ( v3 ) is -92.7 , Pin 4 ( v3 ) is -95
Pins 1 ( v3 ) -226 & Pin 3 = -222

Im not after more power , just wanting to confirm that I was measuring it correctly .
My original post was to describe how I was doing it ( at 1khz ) biased at 500 mA ...and then measured V squared / R ...with the Scope & Fluke DDM . The scopes Peak to Peak reading was multiplied by 0.707 ....and the Fluke DDM is good for 100Khz ( so it says )
I have a Fluke 734 02 series

Cheers Stu
New Zealand on 230 and up to 240 vac

This post is made possible by the generous support of people like you and our sponsors:

Kimber Kable

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---