|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
|
|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Re: ASL Hurricane 6SN7 Dark Filaments posted by Dimitry on June 6, 2006 at 18:26:09:
I have had a few Hurricanes come through with bad filament rectifiers. My concern was what caused them to fail. After some research, I found that a few resistors at the input stage had shorted out taking out the rectifier. If you look at the resistors located at the front of the amp (input stage) you might notice one or two that have their leads very close to other resistor leads or even the body of one of the coupling capacitors. Be sure there is plenty of space around all those tightly fitted resistor leads and you should not come across this again.Bill
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: ASL Hurricane 6SN7 Dark Filaments - Response34 11:16:50 06/10/06 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
