Cable Asylum Interconnects, speaker wire, power cords. Ask the Cable Guys.

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ Cable Asylum ]

---

[ Alert Moderator ]

---

RE: Dumb Question: 75 ohm or 110 ohm?

Posted by HiOnFi (A) on May 29, 2023 at 06:32:33

In Reply to: Dumb Question: 75 ohm or 110 ohm? posted by HiOnFi on May 21, 2023 at 08:03:34:

As I often do, I think about my systems weaknesses even when Im not listening to it. Do you? Today's case in point: CHASING DOWN WEAK BASS. Where I was focused on my S/PDIF cables, it occurred to me to check what power cord I had on my Audio Alchemy PS-5 outboard power supply umbilicaled to my AA DDP-1 DAC/PRE. The mfg was recommended from a friend and sold on Amazon. Now in fairness to him, he said to get the copper version, but I bought the silver over copper: 【Oxygen Free Copper Core】The US power cable is 10AWG Oxygen Free Single Crystal Copper Conductors with low harmonic vibration point and high damping provide optimal transmission.
【Rhodium Plated Plug】it is with US version +C15 Rhodium Plated Plug + Aluminum Alloy Shell making it less susceptible to outside interference, ensure crystal-clear HiFi effects.
【Pure Copper Shielding】the power cord is with High density Red Pure Copper Braid Shielding for low-interference signal transmission,making consistent reliability. Heck of a deal for ~$40, but...

I just swapped it out for a Tekline Audio boutique cable circa ~ 2005 @ ~ $500. Even cold, it has a lot more low end grunt. I'll give it a couple hours then rotate my Pangea Premier SE coax with my NEARdost Odin 2

TBC

This post is made possible by the generous support of people like you and our sponsors:

Kimber Kable

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2025, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---