I wouldn't use XLRs for high voltage!

Tube DIY Asylum

Do It Yourself (DIY) paradise for tube and SET project builders.

In Reply to: Re: Sure but it's not simple... posted by jsn on March 27, 2006 at 12:46:01:

There isn't enough clearance between the pins. There could be arcing from pin to pin. Look for a Amphenol Ribbon or Cannon Military bulkhead connector for the power unbilical. And use heat shrink on the connector pins when you solder wires. Cover all the metal. High voltage can jump a distance. Ray
"I take you as you are
And make of you what I will,
Skunk-bear, carcajou, bloodthirsty
Non-survivor.
Lord, let me die but not die out." THE LAST WOLVERINE by James Dickey

This post is made possible by the generous support of people like you and our sponsors:

McShane Design

Follow Ups Full Thread

Topic - DC umbilicals - jsn 09:54:42 03/27/06 (4)

Re: DC umbilicals - maxhifi 22:59:02 03/27/06 (0)

Sure but it's not simple... - grhughes 12:20:30 03/27/06 (2)

Re: Sure but it's not simple... - jsn 12:46:01 03/27/06 (1)

I wouldn't use XLRs for high voltage! - grhughes 13:08:18 03/27/06 (0)

Follow Ups

I wouldn't use XLRs for high voltage! - grhughes 13:08:18 03/27/06 (0)

You can not post to an archived thread.