|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: About the MP-130 posted by Lynn Olson on March 19, 2006 at 13:59:44:
The P13WH would only need a lowpass at 4KHz and the big bad cap in the midsection would be eliminated. I don't feel so bad about a big cap in the low section because it's probably a lot less audible.The challenge would then be to tune the woofer on to the natural rolloff of the midrange, I have no idea if this would be possible at all. Another problem might be that the P13WH would be in a <10L sub-enclosure, which will probably limit the bass response. I might even feed the woofer from a different amp and go active.. but I'm probably getting a little over enthousiastic now.
On the other hand, these drivers can be had for as little as $40 a piece, so I might as well get a pair and give it a try.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- what if I replace the P13MH for a P13WH - arend-jan 00:08:49 03/20/06 (1)
- Re: what if I replace the P13MH for a P13WH - Lynn Olson 13:45:31 03/20/06 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
