|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: Bias adjustment? Scott 208 posted by DAK on October 20, 2024 at 08:15:51:
Like I mentioned previously I am running the amp through a variac to keep the B+ at sane levels and not wear out the Westinghouse 7591 tubes, because they are so pricey. I was wondering what modifications were done specifically on this amp since it is quite compact and space is an issue.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Also, anyone addressed the high B+ issue on the 208 - DAK 08:24:50 10/20/24 (5)
- RE: Also, anyone addressed the high B+ issue on the 208 - Tre' 07:43:33 10/21/24 (4)
- What pin on the 7591 do I put the 10R resistor? ntd - DAK 12:10:45 10/21/24 (2)
- RE: What pin on the 7591 do I put the 10R resistor? ntd - Tre' 13:02:53 10/21/24 (1)
- RE: What pin on the 7591 do I put the 10R resistor? ntd - DAK 13:17:31 10/21/24 (0)
- RE: Also, anyone addressed the high B+ issue on the 208 - DAK 12:00:19 10/21/24 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
