|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: How to open the side hole on a Hammond? posted by Gusser on August 14, 2006 at 10:55:35:
I use the conical rubber bushings found in plumbing depts. (for faucets i think). Works great.Removing the side hole would ruin the looks for future use, but if you must, try lightly knocking with a punch or screwdriver and hammer, so that it rotates around the small weld spot. Then you can continue with pliers until the weld spot yields.
HTH
Joris
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Try mounting them on rubber bushings for mecanical isolation... - SomeJoe 07:03:19 08/15/06 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
