|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
Getting ready to rebuild my preamp (plus mods) and was thinking about using Juppiter solid-core copper wire 28 awg for signal path sections. Any thoughts? Too thin or thoughts on the Juppiter wire itself?I have found I like copper wire a lot more than silver for the signal path, though that is just my opinion.
This post is made possible by the generous support of people like you and our sponsors:
Topic - Juppiter Wire Question - Paully 17:30:49 07/17/06 (12)
- Re: Juppiter Wire Question - JANDG 19:02:57 07/18/06 (5)
- Where do you get it? - Paully 09:52:57 07/19/06 (4)
- CAT5 - Russ57 11:43:44 07/19/06 (3)
- Re: CAT5 - John Swenson 12:40:47 07/19/06 (2)
- I make no claims to sound - Russ57 14:04:39 07/20/06 (0)
- Re: CAT5 - JANDG 17:29:26 07/19/06 (0)
- It has unwaxed cotton insulation - Paully 08:40:30 07/18/06 (0)
- Re: Juppiter Wire Question - MIchael Samra 19:33:23 07/17/06 (4)
- Re: Juppiter Wire Question - Paully 08:45:54 07/18/06 (0)
- I think the old mil spec silver coated copper stranded... - radiance 20:33:11 07/17/06 (2)
- Most, if not all, Mil-specs wires got lousy copper .. - cheap-Jack 07:38:52 07/18/06 (1)
- Thanks for the tip; I'll check it out, sounds great. (NT) - radiance 09:43:47 07/18/06 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
