|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: wiring pot into amp posted by transamz on July 10, 2006 at 17:21:02:
Disconnect the wire that presently goes to the input jack center terminal & place a 47K resistor in-between that wire & the input jack center terminal. Connect one end-terminal of your pot to the 47K resistor & that wire (not the jack side of resistor). Connect other end-terminal of the pot to pot center terminal & then to input jack outer terminal. Done. This method requires no change to driver board. As you view pot with terminals at bottom & shaft facing you, the Right hand terminal is the one connected to 47K resistor; the Left hand terminal & center terminal are connected together & to input jack outer terminal. IOW, input jack to 47K resistor to 100K pot to driver board with pot shunting to circut Common.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: wiring pot into amp - Ron Oehlert 19:22:43 07/10/06 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
