|
OTL Asylum OTL, Output Transformerless Amplifier User Group. |
|
|
|
OTL Asylum OTL, Output Transformerless Amplifier User Group. |
|
In Reply to: Re: OTL rewiring... posted by boll001@pol-it.org on February 10, 2005 at 10:58:05:
Simple answer: AWG15 is fine for the power supply. I would use AWG26 for the signal wire. If the wire is sold without insulation, just buy some teflon tubing of the appropriate internal diameter(s), and you are in business. But you are not yet in business, if you don't know how to solder. If that is the case, find a professional or advanced amateur who can teach you proper techniques and safety rules. You will also want a good volt-ohm-amp meter, and you will need a solder gun and solder. I recommend a "solder station", which is a set up where you can set the temperature of the solder gun and it is electronically stabilized.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: OTL rewiring... - Lew 11:32:45 02/10/05 (1)
- Re: OTL rewiring... - boll001@pol-it.org 09:22:30 02/11/05 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]