|
OTL Asylum OTL, Output Transformerless Amplifier User Group. |
|
|
|
OTL Asylum OTL, Output Transformerless Amplifier User Group. |
|
In Reply to: Question for Paul Speltz Re: Delay on for input tubes posted by PETE WALTERS on February 21, 2000 at 15:13:21:
I'm not Paul but ...
No! You would be running 300V to the front panel, which
1) is dangerous
2) is likely to degrade your B+
the toggle switches are probably only rated to 250V so they couldn't
handle the high voltage, plus its always a bad idea to route such
high voltages through controls for general safety. Besides
which IIRC both ends of the switch are used already. The relay is
the best solution ..-D
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Question for Paul Speltz Re: Delay on for input tubes - Dan 07:57:08 02/22/00 (1)
- Re: Delayed "on" for input tubes - Paul Speltz 10:08:16 02/22/00 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
