High Efficiency Speaker Asylum Need speakers that can rock with just one watt? You found da place.

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ High Efficiency Speaker Asylum ]

---

[ Alert Moderator ]

---

RE: Mods for BMS 4592ND (pics) Part2

Posted by DHT 4 ME (A) on June 16, 2007 at 22:45:24

In Reply to: Mods for BMS 4592ND (pics) posted by DHT 4 ME on June 16, 2007 at 22:29:45:

here is the tweeter leadout that sits in the hole

In case you can not envision the situation here is a section through the chamber showing the cavity connected to the compression chamber

What I did was find the proper tight fitting stainless steel washer to plug the hole. I don't remember the size but you should be able to get something similar from an ACE hardware store. A little epoxy and 2 pieces of paper for insulation and that is basically it. I did resolder the leadouts for the tweeter to make them a little smaller so there would be less chance of the leads shorting against the stainless washers.
I highly recommend a dial caliper to measure the washer height to leadout clearance. Be sure to check for any shorts too. I guess I figured out how to do multiple pics in a post too :)
Bob

this is the leadout that fits in the recess.

This post is made possible by the generous support of people like you and our sponsors:

Atma-Sphere Music Systems, Inc.

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2025, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---