 
|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
|
|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
74.87.136.238
In Reply to: RE: Disagree, for the most part... posted by Caucasian Blackplate on December 22, 2013 at 22:33:42
(Sorry for the delay in responding, I have been away for Xmas vacation...)
The main reason why I believe that a low(er) output impedance preamp is best is because I have actually tried this thing out for myself.
Toggling my headphone amp's selector switch on both "high" and "low" output impedance settings, the low impedance setting always seems to sound best (when it is used as a "preamp") - at least with the amps I have on hand. But, many headphone amps do not have an output impedance selector switch so not everyone will have the option of experimenting with such a thing, as I have done.
While I cannot say for sure that identical results would be produced in every system, I feel fairly confident in saying that the preamp's output impedance might be something to consider when setting up a system.
Follow Ups:
It really depends a lot on what that switch is doing.
In a solid state headphone amp, it's likely that the output impedance switch would be altering the amount of feedback in the amplifier in order to bring the output impedance down.
In a tube headphone amp, you could be toggling output transformer windings, or in fact also toggling feedback settings (or both).
It isn't surprising that you are hearing differences between these settings, but it is unlikely that it is the actual output impedance itself that is causing your preferences (unless you're driving a very low impedance load, like less than 600 Ohms).
The amp in question (DNA Sonett) is a zero feedback design so I would assume that true, dual output impedance switching is one of it's features. So, for now, I will continue to assume that a low(er) output impedance setting (below 120 ohm "IEC standard") is better when a headphone amp is used as a "preamp" - at least in some cases. Thanks for the input.
Edits: 12/29/13
This is an additional interesting observation. When you switch the impedance setting on that amp from high to low, you are actually using less of the output transformer secondary (less copper), and increasing the step-down ratio.
I have a similar headphone amp in my armada with the same brand of output transformers, and I have actually made observations similar to yours - that I tend to prefer that the amp is set on the lowest impedance setting regardless of what I'm driving.
Post a Followup:
| FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
||||||||||||||
This post is made possible by the generous support of people like you and our sponsors:
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
