|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
|
|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Broken Tube pin guides posted by Jason Michael on February 22, 2007 at 01:57:47:
The tube should still work. You must verify it is plugged in correctly. Turn the amp on without B+. You can do this with the standby switch (if it has one), or be removing the rectifier tube (if it has one). When the tube is plugged in correctly, the heater will be lit.The crack you mentioned apparently has not let air into the tube. If it had, the getter flashing at the top would be milky white. Not to say that it might do so later.
Hope this helps! Al
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Broken Tube pin guides - Alpha Al 07:19:25 02/22/07 (2)
- Re: Broken Tube pin guides - Jason Michael 08:55:57 02/22/07 (1)
- Re: Broken Tube pin guides - Alpha Al 14:27:34 02/22/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
