|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
|
|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Manley Stingray and bias. posted by Jera on February 16, 2007 at 12:52:42:
You probably already know this, but just in case; make sure to turn the volume all the way down and disconnect all interconnects from the amp (leave speaker cables connected) and let the amp warm up for 10 minutes or so before taking your bias readings.As mentioned earlier, the problem (if one exists) is most likely in the amp's bias supply and not the tubes. What sort of problems were your previous tubes giving you? Also, does your amp require bias settings in excess of 20mV?
The small signal tubes aren't related to the bias supply.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Manley Stingray and bias. - Catch22 20:39:30 02/16/07 (1)
- Re: Manley Stingray and bias. - Jera 23:44:47 02/16/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
