In Reply to: RE: question for Michael Samra posted by Michael Samra on March 12, 2017 at 12:18:52:
Thanks, Michael, that is all go to know. Since space is a concern in these old Scotts & Fishers, etc., I often use the voltage values on the schematic and measured in circuit to determine the voltage rating of the caps I replace with. For example, if the plate is only seeing 150 volts, a 250 volt CDE film and foil, which is much smaller that the 400 volt ceramicaps in the Scotts, gets used as it saves space.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: question for Michael Samra - gkargreen 13:44:56 03/12/17 (5)
- RE: question for Michael Samra - Michael Samra 10:55:29 03/14/17 (4)
- RE: question for Michael Samra - gkargreen 11:46:22 03/14/17 (3)
- Take a look at a test I did on the different capacitors. - Michael Samra 13:18:59 03/14/17 (2)
- Michael, what about the K73 caps? - gkargreen 17:33:53 03/14/17 (0)
- RE: Take a look at a test I did on the different capacitors. - gkargreen 14:31:12 03/14/17 (0)