|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Checking motor run caps posted by Blooze on February 5, 2006 at 20:48:39:
Sure,
If you are talking about the metal, oil filled motor run caps. If they are not damaged or leaking. They are probably fine.
You can use your DVM set to ohm’s. Short the terminals with an insulated screw driver or something, just to be safe. Then connect the meter leads.What you are looking to see is the reading going up to a fairly high value. This could take some time, so if it was trending upwards and not a dead short. That would be good enough for me…John
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Checking motor run caps - 2wo 21:28:50 02/05/06 (1)
- Re: Checking motor run caps - Blooze 21:43:11 02/05/06 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
