|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Motor Run mounting posted by BillyJack on January 24, 2006 at 10:03:49:
Almost all of the newer motor run caps have a built in circuit interupter. The terminal, where you connect the wires, will "spring out" in a fault condition and you would want to allow clearance for this to happen. Otherwise, to the best of my knowledge, mounting posistion does not matter. They are commonly installed upside down on motors so rain doesn't cause a short.Russ
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- One important factor don't I don't know if you are aware of - Russ57 18:42:16 01/24/06 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
