|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Re: 6SN7 limbo posted by Mahatma Kane Jeeves on December 17, 2005 at 18:33:20:
I stated before that it was at 14.8V out. And if 100k is NOT your cutoff of acceptability, please do tell us what is. 10k? 1k? Drive them into a short if you like!If I redrew the gm, mu, and rp curves of a 6SN7 with a different scale, they would look anything but "strongly sloped" at 2.8mA, compared to most other tubes.
50k is not the "anode load". 50k in parallel with 47k is 24k, the last time I checked. And further, the distortion is reduced to 1/A, not 1/mu.
Joel
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: 6SN7 limbo - Joel Tunnah 04:44:05 12/18/05 (1)
- Re: 6SN7 limbo - Mahatma Kane Jeeves 06:31:05 12/18/05 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
