Welborne 300b DRD assembly question

Tube DIY Asylum

Do It Yourself (DIY) paradise for tube and SET project builders.

Well, since the Welborne forum is gone, I guess this is the place to ask this question ...
1. I have found that the holes drilled in the top plates for the wires from the power transformer are closer together than where the wires exit the transformers. Consequently, as the wires come through, they are pressing pretty tightly against the hole edges which are sharp. While they have not cut through the insulation yet, there are clear marks on the wires and some of the insulation scraped off during installation. I am worried both about cutting the insulation and thus either sending lots of volts into the top plates or just being unable to repair the transformers. Does anyone have any suggestions of what to do about this, or has anyone else had a similar problem?
-d

This post is made possible by the generous support of people like you and our sponsors:

Kimber Kable

Topic - Welborne 300b DRD assembly question - drsx 12:48:24 09/26/05 (3)

Re: Welborne 300b DRD assembly question - JimBop 19:19:21 09/26/05 (1)

Re: Welborne 300b DRD assembly question - drsx 01:24:13 09/27/05 (0)

Re: Welborne 300b DRD assembly question - sjmikeb 13:34:26 09/26/05 (0)

You can not post to an archived thread.