|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: SE output transformers never have enough inductance. posted by Tre' on December 5, 2024 at 10:48:58:
Insufficient inductance should present as a loss of amplitude at low frequencies, even at very low power levels. That's not the case for the FS-100 transformers I'm using. They're flat to below 20Hz at levels like 1W. It's only at higher levels where the low frequencies suffer. I believe this indicates transformer saturation.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: SE output transformers never have enough inductance. - Triode_Kingdom 10:14:54 12/06/24 (5)
- RE: SE output transformers never have enough inductance. - Tre' 17:49:06 12/06/24 (4)
- FYI: My site it back up - VoltSecond 23:24:54 12/07/24 (2)
- That's great news! - Tre' 09:11:23 12/08/24 (1)
- Active Bi and Tri amp-ing solves a lot of issues! - VoltSecond 22:05:53 12/08/24 (0)
- Very interesting - Thanks! - Triode_Kingdom 18:56:13 12/06/24 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
