Can you run the signal circuit off opposite PSUs?

Tube DIY Asylum

Do It Yourself (DIY) paradise for tube and SET project builders.

Follow Ups Full Thread

Topic - so I built one successful mono block and finished the other - Story 06:37:35 01/13/24 (11)

yay!! I finally found the problem, thanks everybody - Story 12:08:35 01/14/24 (3)

RE: yay!! I finally found the problem, thanks everybody - Triode_Kingdom 15:34:29 01/14/24 (2)

I'm using Sylvania 12sl7's and Russian 6V6's and it sounds better than I hoped it would - Story 10:31:01 01/16/24 (1)

RE: I'm using Sylvania 12sl7's and Russian 6V6's and it sounds better than I hoped it would - Triode_Kingdom 15:47:00 01/16/24 (0)

RE: so I built one successful mono block and finished the other - Tre' 19:06:55 01/13/24 (1)

RE: so I built one successful mono block and finished the other - Story 03:40:14 01/14/24 (0)

Can you run the signal circuit off opposite PSUs? - andy evans 10:14:20 01/13/24 (0)

As they are monoblocks, did you swap positions? - Ivan303 06:55:32 01/13/24 (3)

same speaker on the test bench, same source /NT - Story 08:03:37 01/13/24 (2)

RE: " turn the volume WAY up" - Ivan303 08:09:53 01/13/24 (1)

no volume on the amp, only the pre /nt - Story 09:18:45 01/13/24 (0)

Follow Ups

Can you run the signal circuit off opposite PSUs? - andy evans 10:14:20 01/13/24 (0)

Post a Message!