|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: Tre, do you implement and 'heroic' regulation with the filament as that seems to yield marked improvement~nT posted by RPMac on November 1, 2023 at 16:46:35:
"What does the transformer inductance do to the load line of a tube?""It does not matter if your speaker does not go down to 31.25 Hz or not. If you are sending low frequency information to the amplifier, the amplifier will make the plate voltage move. If the plate voltage moves, the tube must spend bias current to charge and discharge the primary inductance as well as the actual primary load impedance. If the plate voltage or current "clips" because of low frequency plate excursions, the sound will suffer. "
Tre'
Have Fun and Enjoy the Music
"Still Working the Problem"
Edits: 11/02/23 11/02/23
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Tre, do you implement and 'heroic' regulation with the filament as that seems to yield marked improvement~nT - Tre' 06:08:28 11/02/23 (3)
- RE: Tre, do you implement and 'heroic' regulation with the filament as that seems to yield marked improvement~nT - RPMac 05:52:28 11/05/23 (2)
- RE: Tre, do you implement and 'heroic' regulation with the filament as that seems to yield marked improvement~nT - Tre' 06:09:04 11/05/23 (1)
- RE: Tre, do you implement and 'heroic' regulation with the filament as that seems to yield marked improvement~nT - RPMac 09:44:13 11/05/23 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
