|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: How to implement these for my Ultrapath? posted by Tre' on August 7, 2023 at 16:10:44:
My friend suggests I use 500 ohm 1w resistor for the cathode and lower the UP cap to 200uf.
The power supply must be rebuiltt with Vandervern mec electronic choke and Salads HV Shunt reg
He says, once the power supply is regulated, the UP Cap should be way smaller than 200uf. And the ps provided a very low impedance at the same time.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: How to implement these for my Ultrapath? - SuperB 17:04:13 08/07/23 (3)
- If you want to regulate, you are better off - Ralph 08:14:29 08/08/23 (2)
- RE: IRegulated Power Supply - SuperB 12:29:05 08/08/23 (1)
- The Ultrapath is a great setup. - Ralph 12:40:48 08/08/23 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]