|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Re: thank you posted by eedork on March 16, 2007 at 04:11:41:
>>This is probably in the tube data sheets, but what's a good design point for the screen if the plate is running at 275V?<<Matt,
Zobsky gave you a good hint in mentioning the 6p15p/SV83/EL84N's requirements. 150 V. will do nicely. That puts a 0A2 gas discharge regulator "on the map". If you wire your sockets for the 6p15p, 3 decent and affordable tubes are available for "rolling": the 6p15p, the 6p14p-ev, and the JJ EL84.
In any event, use "fixed", as opposed to cathode, bias on your O/P tubes. IMO, you can't afford the voltage drop across a RC bias network.
BTW, you've yet to indicate the heater current capability of your power trafo. Did your console amp support an external tuner?
Eli D.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: thank you - Eli Duttman 16:41:18 03/16/07 (1)
- Re: thank you - eedork 18:49:31 03/16/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
