|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Who made the preamp? posted by Russ57 on March 11, 2007 at 04:37:31:
Thank you for your interest.
It is VAC CPA-1 heavily modified.
I found the problem that caused the imbalance.
It was due to shortage between 2K resistor (the most input-ward) and input wire in DACT 10K attenuator in the left channel. As a result the left DACT attenuator acted as 8K attenuator. [Increase in voltage by a step is proportional to (step resistor value/8) for the left channel instead of (step resistor value/10) for the right channel. So 20% increase in the left channel.] In reality, it is not the reduced output from the right channel but the increased output from the left channel that caused the imbalance.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Who made the preamp? it was due to.... - yhm23280@gmail.com 06:21:26 03/11/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
