|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Cathode Follower Preamp Outputs posted by Sasquatch on January 25, 2007 at 08:35:10:
is the have the a CF load resistor of 1/2 to 1/5 (better) of the load Z. Standing current should be 2 to 5 times the load's peak current draw.The load resistor should be about the same as what would be used if it was a normal grounded cathode amp. So pick the tube accordingly (don't use a 10K load on a 12ax7:).
Russ
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- A rule of thumb.... - Russ57 10:52:56 01/25/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
