|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Are the values for the RRSF generic posted by wheezer on November 2, 2006 at 09:57:20:
All sorts of posts about RRSF can be found in the Bottlehead Forum Archives.Put a HIGH WVDC 100 nF. film cap. across the ends of the rectifier winding. 10 Ohm INDUCTIVE wirewound resistors connect the ends of the rectifier winding to the downstream stuff. A HIGH WVDC 10 nF. ceramic cap. goes across the rectifier bridge side of the 10 Ohm resistors. Measuring with an o'scope will tell you how good a job you're doing in suppressing the "hash". The values I provided will get you off to a good start.
Eli D.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Are the values for the RRSF generic - Eli Duttman 17:08:47 11/02/06 (3)
- Re: Are the values for the RRSF generic - wheezer 09:57:05 11/03/06 (0)
- Eli, how do results compare to snubbers across diodes? - Russ57 05:19:21 11/03/06 (1)
- Re: Eli, how do results compare to snubbers across diodes? - Eli Duttman 17:42:31 11/03/06 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
