|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Re: grid and plate standard? for calibrating a Triplett 3444A posted by DrRick on July 17, 2006 at 15:02:34:
DrRick and Michael,If you're still watching this thread...I did happen to find a scanned copy of the Triplett 3444A manual in my hard drive. I had forgotten that I had it, since I use the paper copy that Triplett had sent me years before. This PDF document is a very high quality scan that I must have pulled off some website. I have the calibration procedure too, but that's a separate blurry scan of a few pages. The manual is just under 7 MB. I can email it out as long as it's under 10MB. If anyone wants it, and is able, to receive this large file, send me your email addresses.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Update: I DO have a scanned copy - BBeck 15:37:24 07/20/06 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
