|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
I just received a TVC pre I ordered. Love it! I had to find a 2 pole 17 gang selector switch to use for a vol control in it. So I found this nice industrial grade one by electro switch. Well this thing is WAYY more industrial than I thought. As the builder of the pre put it "looks like it was used for setting off nukes". Anyway this switch needs what seems like 5 lbs of force to turn and the round knob makes for hopeless effort with slippery hands. Even dry hands can barely move this thing!So... anyone know of a source for a metal rectangular 3/4" shaft knob?
Thanks for the much needed help.
Dave
This post is made possible by the generous support of people like you and our sponsors:
Topic - Source for 3/4" rectangular knob? - 2chJunkie 17:39:19 07/19/06 (7)
- How about..... - PeterP 06:10:28 07/21/06 (0)
- Re: Source for 3/4" rectangular knob? - Tom Bavis 18:19:52 07/20/06 (0)
- I ment to state 1/4" shaft......sorry allot on the mind - 2chJunkie 13:51:29 07/20/06 (1)
- Re: I ment to state 1/4" shaft......sorry allot on the mind - Ron Oehlert 14:42:23 07/20/06 (0)
- National used to make them... for Ham tuning knobs - grhughes 08:49:04 07/20/06 (1)
- If it were only so simple....you see..... - 2chJunkie 13:33:09 07/20/06 (0)
- opps that 17 throw....DUGH (nt) - 2chJunkie 17:42:38 07/19/06 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
