Tape Trail

UPDATE: I Fixed my Luxman K03..

68.7.9.81

This Post Has Been Edited by the Author

In Reply to: RE: Luxman K-03 needs Service. posted by Cougar on December 17, 2020 at 23:30:07

I went over to the Tapeheads Forum and got some great info/help.

My Luxman K03 wasn't recording correctly (distorted) wasn't erasing tapes at all, no matter Brand new tapes or old ones.

So today with all the great help I started looking into my Schematics to get the parts and values that I was planning to replace since this is a common failure with the Luxman/Alpines plus Nakamichi's. I went to the main PCB and was checking the values for the erase and record heads. Everything was good. So saw the connectors that were the erase and record heads right there next to the Test Points I was checking. Disconnected and reconnected a few times. I went back and tried that tape again, this time it did erase and record fine. So it was the Connectors that were oxidized plus two switches on the front panel.

All Bias calibrations and Level calibrations are working fine.

So my Luxman is back to full function and recording nicely as I write this. So much for that Tech saying it would need alot of parts replaced and didn't want to do it. Glad he didn't want to do it, it saved me a lot of money. :)

Follow Ups: