|
Propeller Head Plaza Technical and scientific discussion of amps, cables and other topics. |
|
|
|
Propeller Head Plaza Technical and scientific discussion of amps, cables and other topics. |
|
In Reply to: DIY output power measurement? posted by Richidoo on October 16, 2005 at 12:07:26:
You need to be able to monitor the output, so you can see at what point the signal starts to 'clip' (distort).
There are PC scopes available.
power = voltage^2/resistance
usually at 1 kHz and 8 Ohms
volts in RMS (.707 * peak)
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: DIY output power measurement? - hitsware 08:23:55 10/18/05 (1)
- Great! Thanks n/t - Richidoo 08:32:56 10/18/05 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
