Pro Audio Asylum Pro studio recording equipment and music production/industry.

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ Pro Audio Asylum ]

---

[ Alert Moderator ]

---

RE: Studio monitor volume controls rotation

Posted by John Elison (A) on July 2, 2012 at 09:19:13

In Reply to: RE: Studio monitor volume controls rotation posted by Sumflow on July 2, 2012 at 02:09:04:

The term "flat" does not apply to the level control. The term "flat" normally applies to frequency response. Therefore, if you want to set your monitors "flat" you would set all the equalizer switches to zero-dB. You can set the level control anywhere that provides the volume that you desire.

It seems reasonable that b.l.zeebub is correct that the +4-dB setting is to be used with a balanced connection and the -10-dB setting is to be used with an unbalanced connection so that the speakers play at the same relative volume level in either case. For example, +4-dBu = 1.227653-V RMS and -10-dBV = 0.316228-V RMS. The difference between these is 11.78-dB. Therefore, perhaps the volume level is increased by 11.78-dB as you turn the level control from +4-dB to -10-dB.

Good luck,
John Elison

This post is made possible by the generous support of people like you and our sponsors:

Signature Sound

[ Signature Sound Lounge ]

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2025, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---