74.87.136.238
This Post Has Been Edited by the Author
In Reply to: RE: Can headphone-out be routed to RCA Jacks in-Amp? posted by Rapalyea on December 20, 2013 at 09:16:58
All you would need in most cases is a simple (1/8" or 1/4" plug to dual RCA) adapter cable.However, headphone amps will often have much higher output impedance ratings than real, dedicated preamps do. It is almost always better when the output impedance rating of your "preamp" is very much lower than the input impedance rating of your power amp. If the ratio of output impedance to input impedance is too low, dynamics and/or flat frequency response can become compromised.
So, unless the input impedance rating of your power amp is unusually high, the sound quality you will get from a typical headphone amp (used as a "preamp") will probably not be as good as the sound quality you will get from a decent dedicated preamp with it's much lower output impedance rating.
I do have a pair of ASL Wave 8 tube monoblocks that have unusually high 100 K ohm input impedance ratings. And they do sound surprisingly good when driven by my DNA Sonett tube headphone amp (again, with it's high-ish output impedance rating) - partly because the aforementioned ratio of output to input impedance is acceptably high. Just remember that many (or most) power amps do not have such a high input impedance rating...
But, the basic answer is "YES". A headphone amp can most certainly be used as a makeshift "preamp", in a pinch.
Edits: 12/21/13 12/21/13 12/21/13 12/22/13Follow Ups:
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2013, Audio Asylum, all rights reserved ]
[ Take5 ]