|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: You should test to see if those resistors are good posted by Ralph on March 4, 2025 at 08:31:14:
Ralph: I've unsoldered the resistors and the one on the bottom and take a measure: they are 150 ohm as can see from the very good picture I've found but don't know why somebody added a 200 ohm resistor on top of each one...
I will install new resistors of the same value as I found it but doing a better job for the soldering to avoid problems
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: You should test to see if those resistors are good - katylied 14:25:24 03/05/25 (5)
- "don't know why somebody added a 200 ohm resistor on top of each one" - 1973shovel 05:00:58 03/06/25 (4)
- This doesn't look like a 'factory' repair. - Ralph 09:05:09 03/07/25 (2)
- I sure hope it isn't, Ralph... - 1973shovel 07:44:39 03/08/25 (1)
- RE: I sure hope it isn't, Ralph... - katylied 00:30:07 03/09/25 (0)
- RE: "don't know why somebody added a 200 ohm resistor on top of each one" - katylied 09:55:40 03/06/25 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
