|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: RE: Exactly! posted by Beardy on November 4, 2024 at 21:24:20:
The choice of 3 - 14 Ohm drivers is because of the combined load (4.6 Ohms) on the servo plate amp.The servo plate amp could not drive 4 - 14 Ohm drivers. Aggregate impedance (3.5 Ohms) would be too low.
SW-12-16 parameters:
FS 28.3Hz
BL 14.07
Mms 108g
VAS 100L
Qms 2.8
Qts 0.85
Sd 490cm^2
Re 14 Ohm
X-Max 16 mmIdeally, you would want even numbers of drivers to cancel out non-lineararities of the forwards and backwards cone movements.
.
2022/03/30 Historical Records CENSORED
Edits: 11/04/24
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Exactly! - emailtim 23:01:58 11/04/24 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
