Another Magenpan Unitrac question

Vinyl Asylum

Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ.

Hi,
Thanks to those who responded to my prior Magnepan Unitrac questions. I have another elementary question regarding the cartridge leads. Forgive me if you've already answered the question and I just didn't get it. I have removed the harness that holds the leads. It looks like the leads are soldered into the harness on the tonearm side, but I can't tell for sure. If they were plugged in, it would be a simple task to pull them out and replace with new leads. However, if they are soldered in, as it appears, it would be a difficult task at best to pull them out and replace, especially since the harness is no longer available and cannot be replaced if damaged. So, I'm thinking I should just get new cartridge clips and solder them to the wire, but I'd like your opinions. Thanks,
TLH

This post is made possible by the generous support of people like you and our sponsors:

VH Audio

Topic - Another Magenpan Unitrac question - A4 Owner 11:35:44 02/16/07 (4)

I can solder up some connectors to go from the arm lead to the cartidge clip. - tubesforever 10:21:49 02/17/07 (0)

Re: Another Magenpan Unitrac question - A4 Owner 20:45:40 02/16/07 (1)

Don't give up! - jhorowitz128 04:11:00 02/17/07 (0)

Re: Another Magenpan Unitrac question - jhorowitz128 13:01:05 02/16/07 (0)

You can not post to an archived thread.