Here ya go. Check out the link below.

Vinyl Asylum

Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ.

Follow Ups Full Thread

Topic - Anyone experience this? If so - xaudiomanx 16:08:29 04/02/25 (20)

Well I tried a 5/16" bit and that is too large....nt - Steve Parry 09:37:17 04/17/25 (1)

The closest drill bits would be 9/32" or 7mm. Even then, one might need - alaskahiatt 11:15:47 04/17/25 (0)

RE: Anyone experience this? If so - Capt. Z 07:12:10 04/13/25 (0)

So, what did you decide??? nt - alaskahiatt 09:16:16 04/12/25 (0)

Here's what two AR-XA manuals say, and the AR spindle always causes a tight fit. - alaskahiatt 10:33:09 04/05/25 (1)

RE: Here's what two AR-XA manuals say, and the AR spindle always causes a tight fit. - beach cruiser 17:01:54 04/07/25 (0)

Use a reamer - Lew 15:28:18 04/04/25 (0)

RE: I use a 7mm drill bit - twisted by hand. Or is it 8mm? nt. - andyr 23:50:30 04/03/25 (0)

Used an Xacto knife for decades w/my Thorens... no issues...no injuries...N/T - musetap 17:59:55 04/03/25 (0)

RE: Anyone experience this? If so - welly 16:53:56 04/03/25 (0)

RE: Anyone experience this? If so - flood2 14:11:17 04/03/25 (0)

RE: Anyone experience this? If so - Triode_Kingdom 12:16:07 04/03/25 (0)

RE: Anyone experience this? If so - TexSax 11:06:00 04/03/25 (0)

Pencil always worked for me. - Sondek 08:58:13 04/03/25 (0)

RE: Anyone experience this? If so - George S. Roland 06:49:46 04/03/25 (0)

RE: Anyone experience this? If so - mraudio 23:15:07 04/02/25 (1)

Based on the links and conversion, it looks like the hole is 5/16 of an inch... - Steve Parry 12:35:21 04/03/25 (0)

Here ya go. Check out the link below. - alaskahiatt 23:02:48 04/02/25 (0)

it's a favorite campfire scary story I often tell when it's my turn . - beach cruiser 19:40:33 04/02/25 (1)

The pencil was very useful for rewinding cassettes. )MT( - J. S. Bach 07:54:42 04/03/25 (0)

Follow Ups

Here ya go. Check out the link below. - alaskahiatt 23:02:48 04/02/25 (0)

Post a Message!