Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ.

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ Tweakers' Asylum ]

---

[ Alert Moderator ]

---

RE: soldering Furutech FI-10 15A IEC inlet. It does not strong!

Posted by JerryD6 (A) on July 30, 2007 at 14:07:00

In Reply to: soldering Furutech FI-10 15A IEC inlet. It does not strong! posted by michaelv20850 on July 30, 2007 at 07:13:30:

I recently replaced the stock inlets on three upc200s with the Furutech FI-10, screw type connections. These make a very good mechnical connection. I didn't feel that they needed to be soldered as well. I haven't compared with the FI-10 tab type (didn't know they existed), but the screw type must be mounted on the outside, unless you want to file out the opening. With outside mount the neutral wire will just barely reach if you're careful not to cut off too much (cut right at the clip on connector). The screw type installs fairly easy other than the short neutral wire.

Regards,
Jerry

This post is made possible by the generous support of people like you and our sponsors:

Parts Connexion

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2025, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---