|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
|
|
Tweakers' Asylum Tweaks for systems, rooms and Do It Yourself (DIY) help. FAQ. |
|
In Reply to: Re: Prop speed is ~ 1/2 C. posted by pkell44 on April 30, 2007 at 19:09:34:
That all sounds good except for the XTAL, I think that may not be the right direction, here's why...Way back in history I used to work for an outfit that built FM telemetry transmitters for rockets. A problem was that the rockets were really rough when the motors were running and that vibrated the crystals causing incidental FM which robbed us of useful deviation. So, the solution was to encase the crystal in a little cube of custom molded, very low durometer silicon rubber. Their leads were cut short and brought out along with a case ground using Litz wire. They were then largely isolated from shock and Vib.
Perhaps a similar approach would be of value for audio. Using lead tape seems to me more likely to lower the resonance rather than to provide isolation.
Good luck in your quest...
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Prop speed is ~ 1/2 C. - rick_m 20:38:29 04/30/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
