Home Tubes Asylum

Questions about tubes and gear that glows. FAQ

If only one channel, just swap tubes from left to right.

If the sound problem follows you know what the issue is.

However, given you have the issue after the amp heats up, it is likely another cold solder joint or a failing resistor/cap. Tubes themselves usually do not display this type of failure as the tube reaches full heat in a matter of minutes.

What amp is it?


This post is made possible by the generous support of people like you and our sponsors:
  Kimber Kable  


Follow Ups Full Thread
Follow Ups
  • If only one channel, just swap tubes from left to right. - Chip647 14:49:10 02/08/25 (1)

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.