|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
|
|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Surprising posted by tlea on August 21, 2024 at 07:14:22:
While tube testing is 'not that complicated' as I originally said,
there are some basics that need to be accomplished before you can 'Test' the tube.
There are two basic systems inside a tube (power tube for this conversation)
1: the heater: a filament that is either directly heated or indirectly heated to act as a source of electrons for the second system. The voltage for the filament is fixed for a given tube type, and based on the design, one can look up the current required. For a KT-150, Pins 2 & 7, 6.3 Volts @ 1.7-2.0 amps.
2: the Pentode, the part of the tube that actually amplifies the signal: As the name implies, this tube has 5 elements: Plate, pin 3; Grid 1, pin 5, Grid 2, Pin 4, Grid 3, pin 8, Cathode, Pin 8. In this and many other pentodes, G3 is tied to the Cathode - hence both tie to Pin 8.
The result from your tester said that one tube had 'no output' -
this could be caused by a number of issues: a broken connection from a pin to an element within the glass envelope (not fixable), or the tube has been used and is depleted. There is also a possibility that one of the pins has lost connection with the lead from the tube - hard to test for and not easy to fix.
To test for output, you need to power up the heater circuit, and then have voltage on the plate, Grid 1 & 2 with a circuit to sense the output (meter).
[The voltages are not all the same, and depending upon the tester, are often not performed at full rated voltage]
In a push Pull circuit, having one bad tube is like having 1 flat tyre on a bicycle, you might be able to go somewhere but poorly at best, and you probably will ruin the rim that has the flat.
I encourage that you read the FAQ section of this here asylum (linky below) where you can learn about tubes, amps and testers.
Happy Listening
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Surprising - 6bq5 11:37:22 08/21/24 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
