Tubes Asylum Questions about tubes and gear that glows. FAQ

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ Tubes Asylum ]

---

[ Alert Moderator ]

---

Re: Tubes for Conrad J PV7

Posted by stuck.wilson@gmail.com (A) on May 4, 2007 at 03:28:22

In Reply to: Tubes for Conrad J PV7 posted by perryc_516@yahoo.com on April 29, 2007 at 15:06:15:

i know that they retube them at the factory (just down the road from here!) with philips JAN's.. used to have such a beast until it had 'catastrophic failure'.. and the phono board fried to such an extent that i couldn't do anything with it! i can't say it ever sounded forward and bright, though-- i'd suspect other than your preamp for that.. what about amp/cabling/sources? hell.. i used mine with an adcom 555ii.. so i know that preamp's not bright!

besidedly, though-- if you can find 'em and afford 'em-- put some telefunken smooth plates in the first gain stage.. that'll take the edge off anything-- but lots of good advice in here.. sovtek ax7lps'd be WAAAAY cheaper...

good luck!

d

This post is made possible by the generous support of people like you and our sponsors:

Sonic Craft

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---